11/29/2023 0 Comments Power led connector install![]() ![]() ![]() ![]() STEP 5: Trim any excess light strip length (optional). Repeat this process as necessary until you have finished mounting the LED light strip to the surface. Peel off more backing to expose another section of adhesive before pressing the light strip to the target surface. Line up the light strip’s first section of exposed adhesive against the target surface, press firmly, and smooth the strip down by hand. STEP 4: Apply the light strip to the target surface.īased on where the light strip will plug into a power source, start the installation close to this location. To avoid this issue, gradually peel off the backing to expose about 6 to 18 inches of adhesive at a time. If you pull off the light strip’s entire adhesive backing immediately, there is a high chance that dirt, dust, or other debris will get stuck to the exposed adhesive before you can finish the installation. STEP 3: Peel off the backing to expose the light strip adhesive. As long as the area is clean and dry, LED light strips can adhere to a range of smooth surfaces, including wood, plastic, metal, and vinyl. After cleaning the installation surface, use a clean cloth to dry the area. Use a clean cloth and warm, soapy water (or included alcohol wipes) to clean the area where the LED light strips will be installed. ![]() STEP 2: Clean and dry the installation surface. Check the product information and user manual before cutting any LED light strips, and see “How to Cut LED Strip Lights” further below for detailed steps. However, this isn’t the case for all light strip products. Depending on the specific product, you may be able to cut light strips to fit a given space if they’re too long. Next, use a tape measure to take an accurate measurement of the strips themselves and your desired location for them. If they turn on and function as intended, unplug them and proceed. – Scissors (optional) STEP 1: Test the light strip and take measurements.īefore mounting your chosen LED light strips, first plug them into a power source to ensure that they work. With millions of color options available through the Govee Home app, this 32.8-foot smart LED light strip provides bright, customizable lighting. Our Recommendation: Govee Smart LED Light Strip on Amazon for $32.99 Make sure to select a suitable location for the installation, and take the time to properly clean the surface and allow it to dry to help prevent light strips from falling down after putting them up. Just keep in mind that rough, dirty, or uneven surfaces limit the contact between an LED light strip’s adhesive and the wall, ceiling, or other applicable area. Learning how to put up LED lights in your room is a great way to change the aesthetic of your personal space. RELATED: Are These Highly-Rated LED Lights Worth the Money? How to Install LED Light Strips Use this informative LED lights installation walkthrough for step-by-step setup instructions, as well as guides on how to connect LED lights together and how to cut LED strip lights. After deciding where to put LED lights in your room of choice, the next step is determining how to hang LED light strips on the wall, how to install LED strip lights on the ceiling, or even how to install strip lights under cabinets for kitchen countertop lighting. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |